Powershuttle Transmission – Oil Change - Case 570T Operator's Manual

EVERY 1000 HOURS
Powershuttle transmission – oil change
1. Follow Machine safety position. (Refer Engine - Safety
rules)
2. Open and raise the engine tilt hood.
3. Remove the dipstick (1).
NOTE: Change the oil while the transmission is still warm,
the oil will flow easily.
4. Place a container with suitable capacity under the drain
plug (2).
5. Loosen and remove the drain plug (2).
6. Let the transmission oil drain.
7. Install the drain plug (2). Torque: 80.0 N·m (59.0 lb ft).
8. Fill with new oil of specified type through the dipstick
sheath.
NOTE: Transmission oil capacity. Refer to fluid supply
summary table.
9. Insert the dipstick (1).
10. Check the oil level by means of the dipstick and, if
necessary, add more oil.
11. Lower and lock the engine tilt hood.
12. Remove the safety support strut and lower the loader
attachment.
13. Drive the machine for a few minutes in first and second
gear, then stop the machine.
14. Keep the engine running and transmission in neutral
gear.
15. Engage the parking brake.
16. Check the oil level again by means of the dipstick and,
if necessary, add more oil.
7 - MAINTENANCE
7-43
1
PTIL12TLB0206AB
2
PTIL12TLB0248AB