Case 570T Operator's Manual page 85

4 - OPERATING INSTRUCTIONS
2WD or 4WD
NOTE: The engagement or disengagement of the 4WD
must be carried out with a stopped machine.
NOTE: Machines with or without four wheel drive should
not be allowed to exceed 40 km/h (24.9 mph).
A freewheel descent or towing the machine at excessive
speed may cause loss of control, personal injury to the
operator or damage the transmission. Drive the machine
in the same gear going downhill as would be used when
going uphill.
4WD Switch (1)
1
PTIL14TLB0006AB
This switch has two positions:
"OFF": Rear wheel drive
"ON": 4 wheel drive
NOTE: To prevent undue tire wear when travelling on pub-
lic highways or on any hard surface, it is recommended
that the four wheel drive be disengaged.
4-11