Hydraulic System Breather - Clean - Case 570T Operator's Manual

Hydraulic system breather - Clean

1. Follow Machine safety position. (Refer Engine - Safety
rules).
2. Clean the area around the cap.
3. Remove the cap (1) using the wrench (2) supplied with
the machine.
4. Make sure that no dirt enter the hydraulic oil tank.
5. Use a suitable grease solvent to wash the cap (1).
6. Air-dry the cap.
7. Retighten the plug.
CAUTION
Flying debris!
Compressed air can propel dirt, rust, etc. into
the air. Wear eye and face protection when us-
ing compressed air.
Failure to comply could result in minor or mod-
erate injury.
7 - MAINTENANCE
C0049A
7-30
1
PTIL12TLB0512AB