Backhoe Bucket Remove - Case 570T Operator's Manual

Backhoe bucket Remove

1. Move the machine to a level and firm ground.
2. Lower the stabilizers and place the bucket on the
ground.
3. Stop the engine and remove the starter switch key.
4. Remove the lock rings and pins and the rod/bucket link
pin (1).
CAUTION
Flying objects!
Wear eye protection. Do not strike steel parts
with a steel hammer. Parts may break.
Failure to comply could result in minor or
moderate injury.
5. Start the engine.
6. Retract the bucket cylinder rod.
7. Operate the attachment controls so that the dipper/
bucket pin is not supporting the load of the dipper.
8. Stop the engine and remove the starter switch key.
9. Remove the lock rings and pins and the arm/bucket
link pin (2).
10. Start the engine.
11. Operate the attachment controls so as to disconnect
the dipper from the bucket.
6 - WORKING OPERATIONS
C0024A
6-21
1
PTIL12TLB0166AB