Setting The Backhoe Attachment In Road Travel Position - Case 570T Operator's Manual

Setting the backhoe attachment in road travel position

NOTE: The instruments represented may not exactly correspond to the instruments on your machine.
NOTICE: This procedure must be used for road travel, for operating the loader attachment, when transporting the
machine on a trailer and when parking the machine.
1. Check that the direction-of-travel control lever (1) is in
the neutral position.
2. Make sure that the gearshift lever (2) is in neutral po-
sition.
3. Make sure that the operator's seat is correctly posi-
tioned.
4. Make sure that the machine is resting on the stabilizers
and the loader bucket.
5. Place the backhoe attachment in line with the ma-
chine.
6. Run the engine at about 900 RPM.
7. Completely retract the backhoe bucket (6).
8. Completely retract the boom (7) and side shift the
swing to the right hand side.
NOTE: Retract boom on the other side to side shift the
swing to left hand side.
5 - TRANSPORT OPERATIONS
5-6
1
PTIL12TLB0122AB
2
PTIL12TLB0123AB
3
PTIL14TLB0024AB