Operating The Loader Attachment - Case 570T Operator's Manual

Operating the loader attachment

WARNING
Unexpected movement!
Implements equipped with rear-mounted attachments or rear-towed equipment may tip back when dis-
connecting from the tractor in the transport position. Use a rear jack stand to prevent the implement
from tipping back.
Failure to comply could result in death or serious injury.
The following instructions do not cover all possible condi-
tions of use of the loader attachment. They only constitute
basic information to enable the machine to be operated
correctly. Where possible, always use the loader attach-
ment at full engine speed. The first time it is operated,
maneuver the machine in a clear area, at low speed.
NOTE: Always place the backhoe in transport position for
better stability and traction whenever the loader is used.
Loading operations
To fill the bucket from a stock pile, set the bucket in the
level position and lower the attachment with the control
lever to "float" position.
When the loader has entered the pile, press down the
transmission disconnect button, allow the control lever
to move backwards and then simultaneously operate the
controls to lift and roll back the bucket.
Lift and roll-back of the bucket will increase efficiency as a
level bucket throughout the lifting cycle resists bucket lift
and increases break away effort.
NOTE: Do not be concerned if the bucket is not com-
pletely filled during each pass. Maximum productivity is
determined by the amount of material loaded in a given
period of time. Time is lost if two or more attempts are
made to fill the bucket on each pass.
6 - WORKING OPERATIONS
6-8
1
PTIL14TLB0029AA
2
PTIL14TLB0030AA
W0917A