5 Board Test System
UG-20105 | 2017.12.18
Figure 11.
The Configure Menu
To configure the FPGA with a test sustem design, perform the following steps:
1. On the Configure menu, click the configure command that corresponds to the
functionality you wish to test.
2. In the dialog box that appears, click Configure to download the corresponding
design to the FPGA.
3. When configuration finishes, the design begins running in the FPGA. The
corresponding GUI application tabs that interface with the design are now
enabled.
If you use the Intel Quartus Prime Programmer for configuration, rather than the BTS
GUI, you may need to restart the GUI.
5.3.2 The System Info Tab
The System Info tab shows the board's current configuration. The tab displays the
contents of the Intel MAX 10 registers, the JTAG chain, the board's MAC address, and
other details stored on the board.
®
®
Intel
Cyclone
10 GX FPGA Development Kit User Guide
43