The Epcq Tab - Intel Cyclone 10 GX FPGA User Manual

User DIP Switch
The read-only User DIP Switch control displays the current positions of the switches in
the user DIP switch bank (SW1). Change the switches on the board to see the
graphical display change.
User LEDS
The User LEDs control displays the current state of the user LEDS. Toggle the LED
buttons to turn the board LEDs on or off.
Push Buttons
Read only control displays the current state of the board user push buttons. Press a
push button on the board to see the graphical display change accordingly.
Qsys Memory Map
The Qsys memory map control shows the memory map of the
design running on your board.

5.3.4 The EPCQ Tab

The EPCQ tab allows you to read and write EPCQ flash memory on your board. The
memory table displays the address 0 contents by default after you configure the FPGA.
Note: The EPCQ Tab works only when the board MSEL is configured on AS mode.
Figure 14. The Flash Tab
® ®
Intel Cyclone 10 GX FPGA Development Kit User Guide
46
5 Board Test System
UG-20105 | 2017.12.18
bts_config.sof