Status And User I/O Elements - Intel Cyclone 10 GX FPGA User Manual

4 Development Board Components
UG-20105 | 2017.12.18
Micron
MT28EW01GABA1LPC-0SITES
provided with the board.
For the Intel Cyclone 10 GX FPGA device, the image size is less than 85 Mb. Multiple
images can be stored and selected by the user. The image to be used can be selected
with a group of Push Buttons and LEDs.
The user can select between the images to be loaded into Intel Cyclone 10 GX FPGA.
• Cycling images by pushing button S7
• CFG Intel MAX 10 device displays current number to be used with LEDs D16-D18
• Initiate the reconfiguration by pushing button S12
The signal definition of these buttons and LEDs are shown below:
Table 10. Program Selection Signals Definition
Switch / LED
S7
S12
D16
D17
D18
Side Bus
A group of Side Bus signals are defined between Intel MAX 10 and Intel Cyclone 10 GX
FPGA device to provide a higher speed access through on-board USB-Blaster. This
interface is reserved in harwdare.

4.5 Status and User I/O Elements

4.5.1 Switches
Power Switch
The Power Switch S14 is at the edge of the card. When the switch stub is at higher
position (marked 'OFF'), the power is OFF.
Note: When the board is inserted into a PCIe slot in computer, the power switch is override.
The board is powered ON/OFF with the PCIe system irrespective of the position of the
power switch.
DIP Switches
The DIP switches are on the bottom side of the board, close to the upper edge.
Signal
PGM_SEL
SYS_CONFIG_PB
PGM_LED0
PGM_LED1
PGM_LED2
is installed in manufacturing by default. 2 Gb is
Note
Select program
Reconfigure
indicates the program to be used
PGM_LED [2:0]
® ®
Intel Cyclone 10 GX FPGA Development Kit User Guide
23