Leds - Intel Cyclone 10 GX FPGA User Manual

4 Development Board Components
UG-20105 | 2017.12.18
Table 12. Push Button Definition
Board Reference
S11
USER_PB2
S10
USER_PB1
S8
USER_PB0
S7
PGM_SEL
S12
SYS_CONFIG_PB
S13
C10_RESETn_PB

4.5.3 LEDs

The LEDs are on the top side of the board at the upper right corner.
Table 13. Board LED Definition
Board Reference
D16
PGM_LED0
D17
PGM_LED1
D18
PGM_LED2
D14
LOAD_LED
D15
CFGDONE_LED
D13
ERR_LED
D22
USER_LED3
D19
USER_LED0
D20
USER_LED1
D21
USER_LED2
D23
POK_LED
Signal Name
User available Pushbutton 2
User available Pushbutton 1
User available Pushbutton 0
PFL Image selection. Use this pushbutton to rotate through
three images.
Trigger reconfiguration to Intel Cyclone 10 GX FPGA. The image
used for configuration is selected with PGM_SEL button and
indicated by PGM_NUM LEDs
Trigger logic reset to Intel Cyclone 10 GX FPGA logic. The state
of the configured logic is reset, the configuration remains
unchanged.
Signal Name
Green
Green
Green
Green
Green
Red
Green
Green
Green
Green
Green
Function
Colour
Image 0 is loaded in FPP mode
Image 1 is loaded in FPP mode
Image 2 is loaded in FPP mode
Indicates image is loading
Indicates image loading succeeded
Indicates image loading failed
'0' to light, output from FPGA
'0' to light, output from FPGA
'0' to light, output from FPGA
'0' to light, output from FPGA
Indicates power is OK
® ®
Intel Cyclone 10 GX FPGA Development Kit User Guide
Function
25