Resetting The Switch To Default Configuration - Nortel 325-24T Configuration Manual

Resetting the switch to default configuration

The
default configuration.
The syntax for the
restore factory-default
where the
If the
appears:
Warning the switch/stack will be reset to factory default
configuration
Do you wish to continue
Enter
The
Using DNS to ping and telnet
Using the Domain Name Server (DNS) client, you can ping or telnet to a host
server or to a host by name. To use this feature, you must configure at least one
DNS; you may also configure a default domain name. If you configure a default
domain name, that name is appended to hostnames that do not contain a dot. The
default domain name and addresses are saved in NVRAM.
The hostnames for ping and telnet cannot be longer than 63 alphanumeric
characters, and the default DNS domain name cannot be longer than 255
characters. This section covers these commands:
•
•
•
•
restore factory-default
restore factory-default
parameter instructs the switch not to prompt for confirmation.
[ -y ]
parameter is not included in the command, the following message
[ -y ]
to restore the switch to default.
y
restore factory-default
"show ip dns command" on page 262
"ping command" on page 262
"ip name-server command" on page 263
"no ip name-server command" on page 264
Chapter 7 System configuration using the CLI 261
command resets the switch or stack to its
[ -y ]
(y/n) ?
command is in the privExec command mode.
command is:
System Configuration Guide