Related Publications - Nortel 325-24T Configuration Manual

Ethernet switches 325 and 425
Hide thumbs Also See for 325-24T:
Table of Contents

Advertisement

italic text
plain Courier
text
separator ( > )
vertical line (

Related publications

For more information about using the Ethernet Switch 325/425, refer to the
following publications:
|
)
Release Notes for the Nortel Ethernet Switch 325/425, Software Release 3.6
(217155-C)
Documents important changes about the software and hardware that are not
covered in other related publications.
Configuring VLANs, Spanning Tree, and MultiLink Trunking for Nortel
Ethernet Switches 325 and 425, Software Release 3.6 (320986-A)
Describes how to configure Virtual Local Area Networks (VLAN), Spanning
Tree Protocol (STP), and MultiLink Trunk (MLT) features for the Nortel
Ethernet Switches 325 and 425.
Indicates variables in command syntax descriptions.
Also indicates new terms and book titles. Where a
variable is two or more words, the words are connected
by an underscore.
Example: If the command syntax is
show at <valid_route>
is one variable and you substitute one
valid_route
value for it.
Indicates command syntax and system output, for
example, prompts and system messages.
Example:
Set Trap Monitor Filters
Shows menu paths.
Example: Protocols > IP identifies the IP command on
the Protocols menu.
Separates choices for command keywords and
arguments. Enter only one of the choices. Do not type
the vertical line when entering the command.
Example: If the command syntax is
show ip {alerts|routes}
or
show ip alerts
both.
,
, you enter either
, but not
show ip routes
System Configuration Guide
Preface 35

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

325-24g425-24t425-48t

Table of Contents