334 Chapter 8 Ethernet port management using the CLI
Table 121
auto-negotiation-advertisements
Table 121 auto-negotiation-advertisements command
Parameters and values
port <portlist>
[10-full] [10-half]
[100-full] [100-half]
[1000-full] [1000-half]
[asymm-pause-frame]
[pause-frame]
none
no auto-negotiation-advertisements command
The
advertisements for the switch. This command is used for testing. The syntax for
the
no auto-negotiation-advertisements [port <portlist>]
The
configuration command mode.
Table 122
auto-negotiation-advertisements
Table 122 no auto-negotiation-advertisements command
Parameters and values
port <portlist>
320985-A Rev 01
describes the parameters and variables for the
no auto-negotiation-advertisements
no auto-negotiation-advertisements
Note: The use of this command affects traffic and brings down the link.
no auto-negotiation-advertisements
describes the parameters and variables for the
command.
Description
Enter ports for which you want to configure
advertisements.
These are speed-duplex-pause settings. Any
combination of these settings is allowed, but
parameters must be given in the order shown.
Do not advertise any settings during
auto-negotiation.
command clears all
command is:
command is in the interface
command.
Description
Enter ports for which you want to clear all
advertisements.
no