Keystroke Navigation - Nortel 325-24T Configuration Manual

The system records the last command in a CLI session. However, the last
command is not saved across reboots.
Add the word
or remove the parameters of the actual command. For example, when you enter
the command
address. However, when you enter
the IP address to zero. Refer to
alphabetical list of
Add the word
set the parameters of the command to the factory default values. Refer to
Appendix E, "Command List," on page 447
commands.
When you enter a portion of the command and press the [Tab] key, the system
finds the first unambiguous match of a command and displays that command. For
example, if you enter

Keystroke navigation

You can change the location of the cursor using the key combinations shown in
Table 21.
Table 21 Keystroke navigation
Key combination
Ctrl+
A
Ctrl+
B
Ctrl+C
Ctrl+
D
Ctrl+
E
Ctrl+
F
Ctrl+
H
Tab
Ctrl+
K and
Ctrl+
N or Down arrow
to the beginning of most CLI configuration commands to clear
no
ip stack address 192.32.154.126,
Appendix E, "Command List," on page 447
commands.
no
to the beginning of most CLI configuration commands to
default
+[Tab], the system displays
down
Function
Start of line
Back 1 character
Abort command
Delete the character indicated by the cursor
End of line
Forward 1 character
Delete character left of cursor (Backspace key)
Command/parameter completion
Ctrl+
R Redisplay line
Next history command
Chapter 3 CLI Basics 129
no ip stack address,
for an alphabetical list of
System Configuration Guide
you set the IP stack
the system returns
for an
default
.
download