Show Mac-Address-Table Command - Nortel 325-24T Configuration Manual

144 Chapter 3 CLI Basics

show mac-address-table command

The
MAC address forwarding database table. The syntax for the
mac-address-table
show mac-address-table [vid
[address <H.H.H>] [port <LINE>] [include/exclude <pattern>]
The
Table 26
mac-address-table
Table 26 show mac-address-table command parameters and variables
Parameters and
variables
vid <1-4094>
aging-time
address <H.H.H>
port <LINE>
include/exclude
<pattern>
320985-A Rev 01
show mac-address-table
command is:
show mac-address-table
describes the parameters and variables for the
command.
command displays the current contents of the
<1-4094>
command is in the privExec command mode.
Description
Enter the number of the VLAN you want to display the
forwarding database.
Default is to display the management VLAN's database.
Displays the time in seconds after which an unused entry is
removed from the forwarding database.
Displays a specific MAC address if it exists in the database.
Enter the MAC address you want displayed.
List of ports.
Allows you to filter the results of the command by printing
only those entries in the address table that include or exclude
a given pattern. The value for <pattern> must be a sequence
of 1 to 6 bytes in hex, separated by dashes.
for example:
show mac-address-table
port 1/1-5 address include 00-0E-45-23
show
] [aging-time]
show