Autosave Enable Command; No Autosave Enable Command; Default Autosave Enable Command - Nortel 325-24T Configuration Manual

288 Chapter 7 System configuration using the CLI
Figure 107 show autosave command output
425-48T(config-if)#show autosave
Auto Save:
425-48T(config-if)#

autosave enable command

The
the
autosave enable
autosave enable
The
The

no autosave enable command

The
for the
no autosave enable
The
The

default autosave enable command

The
default value of enabled. The syntax for the
command is:
default autosave enable
The
The
320985-A Rev 01
Enabled
autosave enable
command is:
autosave enable
autosave enable
no autosave enable
no autosave enable
no autosave enable
no autosave enable
default autosave enable
default autosave enable
default autosave enable
command enables the autosave feature. The syntax for
command is in the config command mode.
command has no parameters or variables.
command disables the autosave feature. The syntax
command is:
command is in the config command mode.
command has no parameters or variables.
command defaults the autosave feature to the
default autosave enable
command is in the config command mode.
command has no parameters or variables.