No Lldp Port Status Command - Nortel 325-24T Configuration Manual

306 Chapter 7 System configuration using the CLI
Table 99
command.
Table 99 lldp port status command parameters and variables
Parameters and
variables
port <portlist>
rxOnly
txAndRx
txOnly

no lldp port status command

The
for the
no lldp port <portlist> status
The
Table 100
status
Table 100 no lldp port status command parameters and variables
Parameters and
variables
port <portlist>
default lldp port status command
The
receive status on specified ports to its default value (txAndRx). The syntax for the
default lldp port status
default lldp port <portlist> status
320985-A Rev 01
describes the parameters and variables for the
Description
Specifies the ports affected by the command.
Enables LLDPU receive only.
Enables LLDPU transmit and receive.
Enables LLDPU transmit only.
no lldp port status
no lldp port status
no lldp port status
describes the parameters and variables for the
command.
Description
Specifies the ports affected by the command.
default lldp port status
command disables 802.1ab on ports. The syntax
command is:
command is in the config-if command mode.
command sets the LLDPU transmit and
command is:
lldp port status
no lldp port