Ping Enhancement - Nortel 325-24T Configuration Manual

restore factory-default [-y]
where the
For more information, refer to
page

Ping enhancement

Release 3.6 software extends the ping capabilities of the device. Using the CLI,
you can now specify additional ping parameters, including the number of ICMP
packets to be sent, the packet size, the interval between packets, and the timeout.
You can also set ping to continuous, or you can set a debug flag to obtain extra
debug information.
For more information, see
show interfaces config command
The
status of interfaces and provides supplementary information about the current port
settings for Spanning Tree Protocol.
For more information, see
Autosave enable/disable enhancement
Release 3.6 software extends the ability to set autosave enable/disable using the
Console Interface (Configuration File > Autosave Configuration) and Web-based
management (Configuration > Configuration File).
parameter instructs the switch not to prompt for confirmation.
[-y]
261.
show interfaces config
Chapter 1 About Ethernet Switches 325 and 425
"Resetting the switch to default configuration" on
"Pinging" on page 259.
CLI command displays the current operational
"show interfaces config command" on page 284.
System Configuration Guide
49