No Name Command; Default Name Command - Nortel 325-24T Configuration Manual

322 Chapter 8 Ethernet port management using the CLI
Table 108
Table 108 name command parameters and variables
Parameters and
variables
port <portlist>
<LINE>

no name command

The
string. The syntax for the
no name [port <portlist>]
The
Table 109
Table 109 no name command parameters and variables
Parameters and
variables
port <portlist>

default name command

The
string. The syntax for the
default name [port <portlist>]
The
320985-A Rev 01
describes the parameters and variables for the
Description
Specifies the port numbers to name.
Note: If you omit this parameter, the system uses the port number
you specified in the
Enter up to 26 alphanumeric characters.
command clears the port names; it resets the field to an empty
no name
command is in the config-if command mode.
no name
describes the parameters and variables for the
Description
Specifies the port numbers to clear of names.
Note: If you omit this parameter, the system uses the port number
you specified in the
command clears the port names; it resets the field to an empty
default name
command is in the config-if command mode.
default name
interface
command is:
no name
interface
command is:
default name
command.
name
command.
command.
no name
command.