Table of Contents
Advertisement
44
Chapter 1 About Ethernet Switches 325 and 425
Configuring LLDP using the CLI
For information about configuring LLDP using the CLI, refer to
LLDP using the CLI" on page
Ethernet Switch 425-48T stacking support
With Release 3.6 software, the Ethernet Switch 425-48T can be stacked together
with the Ethernet Switch 425-24T up to eight units high. You can stack the units
using the Ethernet Switch 425 stack cables, which are available in 30 cm (1 foot)
and 1 m (3 foot) lengths. These cables can be ordered separately (order number
AL2018005 and AL2018006, respectively).
For more information about stacking the Ethernet Switch 425-48T and Ethernet
Switch 425-24T devices, see
Username and password enhancement
With Release 3.6 software, you can use the CLI to set usernames as well as
passwords for system access through the Console Interface, CLI, Telnet, and
Web-based management. The syntax for the new
username <username> <password> [ro|rw]
320985-A Rev 01
Note: With Release 3.6 software, the Ethernet Switches 425-24T and
425-48T have stacking enabled by default, which means that ports 26
and 50, respectively, are disabled by default. This is because the cascade
port shares resources with port 26 on the Ethernet Switch 425-24T and
port 50 on the Ethernet Switch 425-48T. Either the cascade port can be
active, or port 26 or 50 can be active.
If you want to use port 26 or port 50 in standalone mode, disable
stacking and reboot the switch.
300.
"Stack operation" on page
username
"Configuring
87.
command is:
Hide quick links:
Advertisement
Table of Contents
