Upgrading Software - Nortel 325-24T Configuration Manual

default ui-button command
The
configuration. The syntax for the
default ui-button
The
The
no ui-button command
The
The syntax for the
no ui-button
The
The

Upgrading software

You can download the Ethernet Switches 325 and 425 software image that is
located in non-volatile flash memory. To download the Ethernet Switches 325 and
425 software image, a properly configured Trivial File Transfer Protocol (TFTP)
server must be present in your network, and the policy switch must have an IP
address. To learn how to configure the switch or stack IP address, refer to
"Assigning and clearing IP addresses" on page
This section covers:
default ui-button
default ui-button
default ui-button
command disables the UI button.
no ui-button
no ui-button
command is in the config command mode.
no ui-button
command has no parameters or values.
no ui-button
Caution: Do not interrupt power to the device during the software
download process. A power interruption can corrupt the firmware image.
Chapter 7 System configuration using the CLI 315
command restores UI button to its default
default ui-button
command is in the config command mode.
command has no parameters or values.
command is:
252.
command is:
System Configuration Guide