Console Port - Nortel 325-24T Configuration Manual

74 Chapter 1 About Ethernet Switches 325 and 425
Table 8
and subnet mask.
Table 8 UI button LED display during change in IP address and subnet mask
Label Color/Status
UI Green
Amber
Base Amber
You cannot set the default IP address through the CLI, SNMP, Console, or WEB
interface.

Console port

The Console port allows you to access the Console Interface (CI) screens and
customize your network using the Console menu options and screens (see
Chapter 2, "Using the console interface," on page
The Console port is a DB-9, RS-232-D male serial port connector. You can use
this connector to connect a management station or console/terminal to the
Ethernet Switch 425 by using a straight-through DB-9 to DB-9 standard serial
port cable. You must use a VT100/ANSI-compatible terminal (for cursor control
and to enable cursor and functions keys) to use the Console port.
The Console port default settings are:
•
•
•
320985-A Rev 01
describes the LED behavior at the time of setting the default IP address
Status
Blinking
Steady
Blinking
Steady
Note: The Console port is configured as a Data Communications
Equipment (DCE) connector. Ensure that your RS-232 cable pinouts are
configured for DCE connections (see
assignments," on page
9600 baud with eight data bits
One stop bit
No parity as the communications format
Description
The UI button has been pushed. The front panel
configuration mode has been activated. The
system is awaiting input.
The input has been accepted
The input has been rejected
The default IP address and subnet mask for this
unit or stack has been set to 192.168.192.168.
93).
Appendix B, "Connectors and pin
425).