Default Flowcontrol Command - Nortel 325-24T Configuration Manual

328 Chapter 8 Ethernet port management using the CLI
Table 116
command.
Table 116 no flowcontrol command parameters and variables
Parameters and
variables
port <portlist>

default flowcontrol command

The
and sets the flow control to auto, which automatically detects the flow control.
The syntax for the
default flowcontrol [port <portlist>]
The
Table 117
command.
Table 117 default flowcontrol command parameters and variables
Parameters and
variables
port <portlist>
320985-A Rev 01
describes the parameters and variables for the
Description
Specifies the port numbers to disable flow control.
Note: If you omit this parameter, the system uses the port
number you specified in the
default flowcontrol
default flowcontrol
default flowcontrol
describes the parameters and variables for the
Description
Specifies the port numbers to default to auto flow control.
Note: If you omit this parameter, the system uses the port
number you specified in the
interface
command is used only on Gigabit Ethernet ports
command is:
command is in the config-if mode.
interface
no flowcontrol
command.
default flowcontrol
command.