Default Lldp Command - Nortel 325-24T Configuration Manual

Table 58 describes the parameters and variables for the
Table 91 lldp command parameters and variables
Parameters and
variables
tx-interval
<5-327698>
tx-hold-multiplier
<2-10>
reinit-delay <1-10>
tx-delay <1-8192>
notification-interval
<5-3600>

default lldp command

The
default lldp
default values. The syntax for the
default lldp [tx-interval] [tx-hold-multiplier]
[reinit-delay] [tx-delay] [notification-interval]
If no parameters are specified, the
to their default values.
The
default lldp
Table 92 describes the parameters and variables for the
command.
Table 92 default lldp command parameters and variables
Parameters and
variables
tx-interval
tx-hold-multiplier
Chapter 7 System configuration using the CLI 301
Description
Sets the interval between successive transmission cycles.
Sets the multiplier for tx-interval used to compute the Time To Live
value for the TTL TLV.
Sets the delay for re-initialization attempt if the adminStatus is
disabled.
Sets the minimum delay between successive LLDP frame
transmissions.
Sets the interval between successive transmissions of LLDP
notifications.
command sets the LLDP transmission parameters to their
default lldp
default lldp
command is in the config command mode.
Description
Sets retransmit interval to the default value (30).
Sets transmission multiplier to the default value (4).
command.
lldp
command is:
command sets all parameters
default lldp
System Configuration Guide