Reload Command - Nortel 325-24T Configuration Manual

136 Chapter 3 CLI Basics
Table 23
Table 24 shutdown command parameters and variables
Parameters
and variables
force
minutes-to-wait
<1-60>]
cancel
The

reload command

The
prevent loss of connectivity to a switch, typically for remote configurations. The
reload
specified time period (1 to 60 minutes), allowing you to make a number of
configuration changes on remote switches without affecting the current saved
configuration. During the interval in which the autosave feature is disabled by the
reload
manual save of your configurations.
Initiate the
commands. Once you initiate the command in the CLI, the following message
appears:
Reload (y/n) ?
Enter yes at this prompt to set the switch reload.
The following warning message then appears:
320985-A Rev 01
describes the parameters and variables for the
Description
Instructs the switch to skip the shutdown confirmation prompt.
Specifies the number of minutes that pass before the switch resets
itself. The default wait time is set at 10 minutes.
Aborts all scheduled switch shutdowns
Note: Any configurations or logins performed on the switch after the
shutdown command is initiated are not saved to NVRAM and are lost
after the reset.
command is in the privExec command mode.
shutdown
command provides you with a configuration rollback mechanism to
reload
command allows you to temporarily disable the autosave feature for a
command, you must use the
command before you start the switch configuration
reload
shutdown
copy config nvram
command.
command to force a