Configuring High Speed Flow Control - Nortel 325-24T Configuration Manual

Configuring high speed flow control

You can view the High Speed Flow Control parameters for Ethernet Switch 325/
425 in this page.
To configure high speed flow control:
1
Figure 161 High Speed Flow Control page
Table 147
Table 147 High Speed Flow Control page items
Item Range
Port
Autonegotiation (1) Enabled
(2) Disabled
Flow Control (1) Enabled
(2) Symmetric
(3) Asymmetric
Chapter 12 Configuring the switch using Web-based management
From the main menu, choose Configuration > High Speed Flow Control.
The High Speed Flow Control page opens
describes the items on the High Speed Flow Control page.
Description
The switch port number of the corresponding row.
Displays if the autonegotiation feature is enabled or disabled.
When enabled, the port advertises support only for 1000Mb/s
operation in full-duplex mode.
Displays current settings of flow control.
(Figure 161).
System Configuration Guide
393