Chapter 12
Configuring the switch using Web-based
management
The switch configuration options available to you are:
•
•
•
•
•
•
•
•
•
•
Configuring BootP, IP, and gateway settings
You can configure the BootP mode settings, create and modify the In-band stack
and In-band switch IP addresses and In-band subnet mask parameters, and
configure the IP address of your default gateway.
To configure BootP, IP, and gateway settings:
"Configuring BootP, IP, and gateway settings"
"Modifying system settings" on page 389
"Configuring switch port autonegotiation speed" on page 390
"Configuring high speed flow control" on page 393
"Downloading switch images" on page 394
"Downloading ASCII configuration files" on page 396
"Storing and retrieving a switch configuration file from a TFTP server" on
page 397
"Enabling and disabling autosave" on page 400
"Configuring port communication speed" on page 400
"Configuring Rate Limiting" on page 402
Note: Settings take effect immediately when you click Submit.
System Configuration Guide
385