Setting Boot Parameters; Boot Command - Nortel 325-24T Configuration Manual

274 Chapter 7 System configuration using the CLI
Figure 101 show sys-info command output
425-48T(config-if)#show sys-info
Operation Mode:
MAC Address:
Reset Count:
Last Reset Type:
Power Status:
Autotopology:
Local GBIC Type:
Local GBIC Type:
sysDescr:
Mfg Date:
Serial #:
Operational State:Normal
sysObjectID:
sysUpTime:
sysNtpTime:
sysServices:
sysContact:
sysName:
sysLocation:
425-48T(config-if)#

Setting boot parameters

You can reboot the switch or stack and configure BootP. The topics covered in
this section are:
•
•
•
•

boot command

The
the
boot
boot [default]
320985-A Rev 01
Switch
00-0F-CD-BF-1E-80
35
Management Reset
Primary Power
Enabled
(port 49) GBIC is missing
(port 50) GBIC is missing
Ethernet Switch 425-48T
HW:00 FW:3.5.0.2
05122004
SACC2600E5
1.3.6.1.4.1.45.3.57.1
0 days, 00:38:44
SNTP not synchronized.
3
c
Ethernet 425-48T
"boot command"
"ip bootp server command" on page 275
"no ip bootp server command" on page 276
"default ip bootp server command" on page 276
command performs a soft-boot of the switch or stack. The syntax for
boot
command is:
SW:v3.6.0