Port Numbering - Nortel 325-24T Configuration Manual

The initial command mode in CLI depends on your access level when you logged
into the Ethernet Switch 325/425 CI menus:
•
•
•

Port numbering

The port numbering for different versions of Ethernet switches are listed below:
•
•
•
•
The CLI uses the variable
ports for the command.
With no password protection, you can enter the CLI in userExec mode, and
use the command to move to the privExec command mode.
enable
If you have logged into the CI menus with read-only access, you can enter the
CLI in userExec mode and cannot access any other CLI command modes.
If you have logged into the CI menus with read-write access, you can enter the
CLI in privExec mode and use the commands to move to the other command
modes.
Ethernet Switch 325-24T has twenty-four 10/100 Mb/s ports.
Ethernet Switch 325-24G has twenty-four 10/100 Mb/s ports and two
10/100/1000 ports.
Ethernet Switch 425-24T has twenty-four 10/100 Mb/s ports on the front, as
well as two combo ports, which includes two GBIC or two copper ports
10/100/1000Mbps.
Ethernet Switch 425-48T has forty-eight 10/100 ports on the front, as well as
two combo ports, which includes two GBIC or two copper ports
10/100/1000Mbps.
Note: The Ethernet Switch 425-24T operates either in standalone mode
or in stack mode. The format of the variable
you are working on a standalone Ethernet Switch 425-24T or a stack.
when a command specifies one or more
<portlist>
Chapter 3 CLI Basics 123
is different if
<portlist>
System Configuration Guide