Configuring The Instant Internet Unit Through A Dial-Up Connection; Figure 11 Command Prompt - Nortel BayStack Instant Internet 400-S User Manual

6
From the Bits per second list, select 115200 to set the modem speed, and then
click OK.
HyperTerminal establishes a connection to the Instant Internet unit. If the
Instant Internet unit is password protected, the session begins by requesting a
password. Enter the password for the Instant Internet unit and then press
Enter.
When you successfully log on, the command prompt is displayed
you can begin using remote access commands to configure the unit.

Figure 11 Command prompt

BayStack Instant Internet(tm) version 7.11
Copyright (c) 1995-2000 Nortel Networks Corporation
ii>
Configuring the Instant Internet unit through a dial-up
connection
To configure the unit through a dial-up connection using the out-of-band
management feature, you must:
• Connect the modem to a PC.
• Use a terminal emulation software application to configure the modem
connection settings.
• Connect the modem to your Instant Internet unit.
Note: If you enter an incorrect password, the message "Incorrect
Login" is displayed and you are prompted to enter a correct password.
You are given two more chances before Instant Internet ends the session
and disconnects you.
Chapter 7 Out-of-band management support
Setting Up the BayStack Instant Internet 400-S Unit
69
(Figure 11) and