Configuring Qos Access Lists; Qos Acl-Assign Command; Nortel Ethernet Routing Switch 4500 Series - Nortel 4524GT Configuration

44 Chapter 2 Configuring Quality of Service (QoS) with the CLI
Parameter
diag [mask | resource]
ip-acl <1 - 65535>
l2-acl <1 - 65535>
capability [meter | shaper]
[port <portlist>]
The show qos command is executed in the Privileged EXEC command
mode.
Configuring QoS Access Lists
The CLI commands described in this section allow for the configuration
and management of QoS access lists. For information on displaying this
information, refer to

qos acl-assign command

The qos acl-assign command is used to assign ports to an access list.
The syntax for the qos acl-assign command is
qos acl-assign
"qos acl-assign parameters" (page 44)
command.
qos acl-assign parameters
Parameter
<1 - 55000>
enable
port <port_list>
acl-type {ip | l2}
name <name>
Copyright © 2007, Nortel Networks
.
Description
Displays the diagnostics entries. Mask displays
the QoS mask precedence use, and resource
displays the QoS resource use.
Displays the specified IP access list assignment
entry.
Displays the specified Layer 2 access list
assignment entry.
Displays QoS meter or shaper port capabilities.
"Displaying QoS Parameters" (page
[<1 - 55000>] [enable]
[port <port_list>]
acl-type {ip | l2}
name <name>
Description
A unique identifier for the access list assignment.
Enable the access-list assignment entry.
The list of ports assigned to the specified access list.
The type of access list used; IP or Layer 2.
The name of the access list to be used. Access lists
must be configured before ports can be assigned to
them. Refer to
"qos l2-acl command" (page 46)
performing these tasks.

Nortel Ethernet Routing Switch 4500 Series

Configuration — Quality of Service
NN47205-504 (322816-B)
5.1 23 November 2007
outlines the parameters for this
"qos ip-acl command" (page 45)
for information on
03.01 Standard
39).
and