Logging Command - Nortel 5510 Configuration

16 Chapter 1 General System Monitoring Considerations
show logging [config] [critical] [serious] [informational]
[sort-reverse]
The show logging command is executed in the Privileged EXEC
command mode.
" show logging parameters" (page 16)
command.
show logging parameters
Parameter
config
critical
serious
informational
sort-reverse

logging command

The logging command configures the system settings for the system
event log.
The syntax for the logging command is:
logging [enable | disable] [level critical | serious |
informational | none] [nv-level critical | serious | none]
The logging command is executed in the Global Configuration command
mode.
" logging parameters" (page 16)
logging parameters
Parameter
enable | disable
level critical | serious |
informational | none
nv-level critical | serious |
none
no logging command
The no logging command disables the system event log.
Copyright © 2005 - 2007, Nortel Networks
.
Description
Display configuration of event logging.
Display critical log messages.
Display serious log messages.
Display informational log messages.
Display informational log messages in reverse
chronological order (beginning with most
recent).
Description
Enables or disables the event log (default is
Enabled).
Specifies the level of logging stored in DRAM.
Specifies the level of logging stored in NVRAM.
Nortel Ethernet Routing Switch 5500 Series
Configuration - System Monitoring
NN47200-505 03.01 Standard
5.1 27 August 2007
describes the parameters for this
describes the parameters for this command.