Assigning The Handwheel Through The Ppu - Siemens SINUMERIK 808D User Manual

6.4.2

Assigning the handwheel through the PPU

Pre condition
Set MD14512[16].7 = 80 (default value: 0). With this setting, you can only assign the handwheel through the PPU.
Op e rating sequence (activating the handwheel control function on the PPU)
If this function is already active, skip the steps below and proceed directly to the operating sequence for assigning the
handwheel through the PPU.
+
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017
3. Press the desired axis traversing keys to assign the handwheel.
4. Press the increment keys on the MCP to select the required override increment.
1: The override increment is 0.001 mm.
•
10: The override increment is 0.010 mm.
•
100: The override increment is 0.100 mm.
•
5. Rotate the handwheel to make the selected axis approach the workpiece.
6. Cut the surface of the workpiece to verify the handwheel assignment.
7. Press this softkey to close the window for handwheel assignment.
8. Press this key to return to the main screen of the machining operating area.
1. Select the system data operating area.
2. Open the machine data window.
3. Press this softkey to open the basic machine data list.
4. Press this softkey to open the search field and enter the machine data "14512".
5. Confirm your entry with this softkey. Then the system starts searching automatically.
6. Move the cursor to the input field for 14512[16].
7. Enter the value "80".
8. Confirm your entry.
9. Press this vertical softkey to activate the value change. Note that the control system restarts
to accept the new value.
25