Arbitrary Positions - Cycle802 - Siemens SINUMERIK 808D User Manual

12.5.4

Arbitrary positions - CYCLE802

Programming
CYCLE802 (111111111, 111111111, X0, Y0, X1, Y1, X2, Y2, X3, Y3, X4, Y4)
Pa rameters
Pa rameter D a ta type
PSYS INT
PSYS INT
X0 REAL
Y0 REAL
X1 REAL
Y1 REAL
X2 REAL
Y2 REAL
X3 REAL
Y3 REAL
X4 REAL
Y4 REAL
Fu n ction
This cycle allows you to freely program positions, i.e., rectangular or polar. Individual positions are approached in the order
in which you program them.
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017
5. Confirm your settings with this softkey. The cycle is then automatically transferred to the
program editor as a separate block.
D e scription
Internal parameter, only the default value 111111111 is possible
Internal parameter, only the default value 111111111 is possible
First position in the X axis
First position in the Y axis
Second position in the X axis
Second position in the Y axis
Third position in the X axis
Third position in the Y axis
Fourth position in the X axis
Fourth position in the Y axis
Fifth position in the X axis
Fifth position in the Y axis
185