N o te
When programming in ISO mode, you need to set the H numbers of T1 and T2 to 1 and 2 in the tool list respectively;
•
Cut the workpiece manually after machining is over.
•
Op e rating sequence for programming in Siemens mode
246
1.
Select the program management operating area.
2.
Press this softkey to enter the system directory for storing part programs.
3.
Press this softkey and enter the name of the new program.
4.
Press this softkey to confirm your entry. The part program editor window opens automatical-
ly.
5.
Enter the following program in the window. The control system saves your editing automati-
cally.
6.
Open the window for CYCLE71 through the following softkey operations:
→
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017