Siemens SINUMERIK 808D User Manual page 271

Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017
24. Press this softkey to accept the changes and open the cycle programming window.
25. Proceed through the steps described earlier to copy the entire program block for POCKET4
and paste it in the line after the above blocks.
26. Press this softkey to open the window for POCKET4. Change the values of "MID", "FFD"
and "VARI" to "5", "100" and "12" respectively.
27. Press this softkey to accept the changes and open the cycle programming window.
28. Press this key and continue to enter the following program blocks and then press this key
again:
G0 Z100 M9
T3 D1
M6
S4000 M3 M8
29. Open the window for SLOT2 through the following softkey operations:
→
Enter the desired parameters as follows:
30. Press this softkey to confirm your input and open the cycle programming window.
Continue to enter the following blocks:
G0 Z100 M9
T4 D1
M6
S1200 M3 M8
31. Press this key to enter a new line.
32. Open the window for CYCLE83 through the following softkey operations:
→
→
271