Rigid Tapping - Cycle84 - Siemens SINUMERIK 808D User Manual

Programming example 2: Deep-hole drilling
Proceed through the following steps:
12.4.6

Rigid tapping - CYCLE84

Programming
CYCLE84 (RTP, RFP, SDIS, DP, DPR, DTB, SDAC, MPIT, PIT, POSS, SST, SST1, AXN, 0, 0, VARI, DAM, VRT)
Pa rameters
Pa rameter D a ta type
RTP REAL
RFP REAL
SDIS REAL
DP REAL
DPR REAL
DTB REAL
166
1. Select the desired operating area.
2. Open the vertical softkey bar for available drilling cycles.
3. Press this softkey to open the window for CYCLE83. Parameterize the cycle as desired.
4. Confirm your settings with this softkey. The cycle is then automatically transferred to the
program editor as a separate block.
D e scription
Retraction plane (absolute)
Reference plane (absolute)
Safety clearance (enter without sign)
Final drilling depth (absolute)
Final drilling depth relative to the reference plane (enter without sign)
Dwell time at final drilling depth (chip breakage)
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017