Siemens SINUMERIK 808D User Manual page 15

Pre -defined labeling strips for keys of the MCP
The MCP package includes two sets (six pieces each) of pre-defined labeling strips. One set (
turning variant of the control system and pre-inserted on the back of the MCP. The other set (
milling variant of the control system.
If your control system is a milling variant of the control system, replace the pre-inserted labeling strips with the milling-
specific ones.
If the pre-defined labeling strips cannot meet your needs, proceed as follows to make customized labeling strips by using the
A4-sized blank plastic sheet in the MCP package:
1. Open the "Symbols for MCP customized key_808D" file in the "\examples\SINUMERIK_808D\MCP" folder on the
Toolbox DVD for the control system on your computer.
2. Copy the desired symbols of keys from the file and then paste them to the desired locations for key labels in the
"Strip_template_808D" file.
3. Print the final labeling strip template file on the blank plastic sheet.
4. Replace the pre-inserted labeling strips from the MCP with the customized ones.
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017
①
as shown below) is for the
②
as shown below) is for the
15