Siemens SINUMERIK 808D User Manual page 34

Ed iting an external part program on the PPU
You can edit an external part program directly on the PPU. Note that the program can be edited only when it is not being
executed.
34
D. Place the cursor on the desired insertion point in the program and press this softkey. The
content of the buffer memory is pasted.
7. If you want to program cycles, press the corresponding softkey to open the desired cycle
programming window. For more information, see Section "Cycles (Page 152)".
8. If you want to program contours, press this softkey to open the contour programming win-
dow. For more information, see Section "Free contour programming (Page 306)".
9. Press this key to return to the program management operating area after finishing editing.
N o te:
When you are in the main screen of the program management operating area, you can
select to make the following operations between programs:
Searching for programs
•
Copying/cutting/pasting programs
•
Deleting/restoring programs
•
Renaming programs
•
For more information, see Section "Program management operating area (Page 281)".
N o te:
Steps 1 to 3: Search for a program file
Steps 4 to 7: Edit the selected program in the open program editor window
1. Select the program management operating area.
2. Press the desired softkey to enter the target program directory.
3. Follow the above steps 3 and 4 for editing an internal program to search for and open the
desired program file.
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017