Tapping With Compensating Chuck - Cycle840 - Siemens SINUMERIK 808D User Manual

Programming example 2: Rigid tapping
Proceed through the following steps:
12.4.7

Tapping with compensating chuck - CYCLE840

Programming
CYCLE840 (RTP, RFP, SDIS, DP, DPR, DTB, SDR, SDAC, ENC, MPIT, PIT, AXN)
Pa rameters
Pa rameter D a ta type
RTP REAL
RFP REAL
SDIS REAL
DP REAL
170
1. Select the desired operating area.
2. Open the vertical softkey bar for available drilling cycles.
3. Press this softkey from the vertical softkey bar.
4. Press this softkey to open the window for CYCLE84. Parameterize the cycle as desired.
5. Confirm your settings with this softkey. The cycle is then automatically transferred to the
program editor as a separate block.
D e scription
Retraction plane (absolute)
Reference plane (absolute)
Safety clearance (enter without sign)
Final drilling depth (absolute)
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017