Milling A Rectangular Spigot - Cycle76 - Siemens SINUMERIK 808D User Manual

12.6.4

Milling a rectangular spigot - CYCLE76

Programming
CYCLE76 (RTP, RFP, SDIS, DP, DPR, LENG, WID, CRAD, PA, PO, STA, MID, FAL, FALD, FFP1, FFD, CDIR, VARI, AP1,
AP2)
Pa rameters
Pa rameter D a ta type
RTP REAL
RFP REAL
SDIS REAL
DP REAL
DPR REAL
LENG REAL
WID REAL
CRAD REAL
PA REAL
PO REAL
STA REAL
MID REAL
FAL REAL
FALD REAL
FFP1 REAL
FFD REAL
CDIR INT
200
If you desire to edit and store the contour as a section of a main program, press this softkey.
N o te:
For more information about programming in the contour editor, see Section "Free contour
programming (Page 306)".
5. Press this softkey to return to the screen form for CYCLE72. Parameterize the cycle tech-
nology data as desired.
6. Confirm your settings with this softkey. The cycle is then automatically transferred to the
program editor.
N o te:
The cycle program created as a section of the main program must be stored after the M30
command.
7. If you desire to recompile the cycle, press this softkey.
D e scription
Retraction plane (absolute)
Reference plane (absolute)
Safety clearance (enter without sign)
Final drilling depth (absolute)
Final drilling depth relative to the reference plane (enter without sign)
Spigot length
Spigot width
Spigot corner radius (enter without sign)
Reference point, first axis of plane
Reference point, second axis of plane
Angle between longitudinal axis and first axis of plane
Maximum depth infeed (incremental; enter without sign)
Final machining allowance at the margin contour (incremental)
Finishing allowance at the base (incremental, enter without sign)
Feedrate for surface machining
Feedrate for depth infeed
Milling direction (enter without sign)
Values:
0: Down-cut milling
1: Conventional milling
2: With G2 (independent of spindle direction)
3: With G3
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017