Siemens SINUMERIK 808D User Manual page 258

258
37. Proceed through the steps described earlier to copy the entire program block for POCKET3
and paste it in the line after the above program blocks.
38. Press this softkey to open the window for POCKET3 again. Move the cursor to the input
field for "VARI" and change its value to "12".
39. Press this softkey to accept the change and open the cycle programming window.
40. Place the cursor on the end-of-block character of POCKET3 with the cursor keys and press
this key to enter a new line.
Continue to enter the following program blocks and then press this key again:
G0 Z150 M9
T6 D1
M6
G0 Z100
S4000 M3
G00 Z50 X36 Y24.1
41. Open the window for CYCLE82 through the following softkey operations:
→
Enter the desired parameters as follows:
42. Press this softkey to call this cycle modally.
43. Press this softkey to confirm your input.
44. Open the window for HOLES2 through the following softkey operations:
→
→
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017