A.2.2 "Auto" Mode - Siemens SINUMERIK 808D User Manual

A.2.2 "AUTO" mode
Ove rview
The machine must have been set up for "AUTO" mode according to the specifications of the machine manufacturer. You can
perform such operations as program start, stop, control, block search, and real-time simulation and recording, etc.
So ftkey functions
Pressing this key in the machining operating area switches to "AUTO" mode.
①
Zooms in the actual value window
②
Performs the program test, dry run, conditional stop, block skipping, and auxiliary function lock
③
Finds the desired block location
④ Corrects a wrong program block. Any changes will be stored immediately.
⑤
Activates the simulation function
⑥ Sets the frequently used setting data
⑦
Displays important G functions
⑧ Displays currently active auxiliary and M functions
⑨
Displays the axis feedrate in the selected coordinate system
⑩ Displays the information of part machining time (part timer) and part counter
⑪ Switches over the coordinate system in the actual value window
An extended horizontal softkey bar can be accessed via this key on the PPU. The following extended
horizontal softkey is provided:
294
Assigns and activates the handwheel or contour handwheel. For more infor-
mation, refer to Section "Assigning the handwheel through the MCP (Page 24)"
and Appendix "Activating the contour handwheel via the NC program
(Page 296)".
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017