Siemens SINUMERIK 808D User Manual page 36

/
36
C. Press this softkey to copy the selection to the buffer memory.
- OR -
Press this key/softkey to delete the selected program blocks and to copy them into the buff-
er memory.
D. Place the cursor on the desired insertion point in the program and press this softkey. The
content of the buffer memory is pasted.
C u tting a row of program blocks
•
With this softkey, you can delete the entire program row where the cursor is placed and
copy into the buffer memory. Then you can move the cursor to the desired position and
press the following softkey to paste the cut program row at the current cursor position:
U n doing/redoing operations
•
Pressing this softkey allows you to revoke your last operation.
Pressing this softkey allows you to restore your last operation that is revoked.
6. Save the program file after finishing editing through the following softkey operations:
→
If you switch to any other operating area after finishing editing without saving, a message
appears to remind you to save the file, for example:
In this case, you may press either of the following softkeys as desired:
Pressing this softkey aborts the editing results and system switches to the desired operating
area.
Pressing this softkey saves the editing results before the system switches to the desired
operating area.
7. Press this key to return to the program management operating area.
N o te:
When you are in the main screen of the program management operating area, you can
select to make the following operations between programs:
Searching for programs
•
Copying/cutting/pasting programs
•
Deleting programs
•
Renaming programs
•
For more information, see Section "Program management operating area (Page 281)".
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017