Run the vent hose down to the ¾" tube near the battery and attach it to the tube using a zip tie.
Brake System
Tube bender,
3
or sand paper, brake fluid.
Pedal Components, Insulated clip hardware, Brake line components,
assembly
Brake reservoir
There are two ways to plumb the brake fluid reservoirs. One way is to use two reservoirs, one for each
master cylinder. The other way is only use one reservoir and put a "Y" in the line to go to the two
reservoirs.
There are also two ways to mount the reservoirs, in the engine bay or over the pedal box. If locating them in
the pedal box it is necessary to cut the access panel location in the body later in the build to allow filling of
the reservoir. The some of the following pictures show the older style reservoir.
Unpack the master cylinder reservoir fittings and the reservoir kit from the pedal-box assembly.
", ¼",
", ⅝" drill bits, drill, rivet gun, marker, tape measure, razor knife, round file
/
/
7
16
16
www.factoryfive.com
186
508-291-3443
" brake lines, Front caliper/rotor
/
3
16