Factory Five Racing MK4 ROADSTER Assembly Manual page 403

The roll bar holes are marked on the body and need to be cut out using a 1¾" holes saw. The front two holes
are cut centering the saw in the marked circle and drilling vertically to match the angle the bar comes through
the body.
To cut the rear roll bar leg, make 2 holes overlapping so that they form the right length. Use the same 1¾" hole
saw centered in the front of the traced opening and with the drill leaning at a 45° angle toward the inner front
leg. Stop the drill when it has cut through half of the hole.
402
www.factoryfive.com 508-291-3443