Factory Five Racing MK4 ROADSTER Assembly Manual page 252

Complete kit

Hide thumbs Also See for MK4 ROADSTER:

Table of Contents

Make sure that the lower hose is not hanging down. If necessary, zip tie the hose to the frame.

Mark the tube where it needs to be cut so that the tube will just touch the attaching location.

Remove the tube/hose assembly from the vehicle.

Cut the tube using a hack saw or if available a cut-off wheel. If necessary clean the end up with tin snips or a

Shake and blow the tube out so that no metal pieces are in the tube.

Remount the tube assembly and tighten the hose clamps on the mount locations.

After running the car for the first time once coolant is added and while the system is still warm, retighten

the hose clamps used on the cooling system.

www.factoryfive.com

508-291-3443