Notes And Restrictions; Notes On Using External Dvd Drive; Notes On Using Usb Memory - Fujitsu M10 Product Notes

Chapter 5
Information on SPARC M10-4
Hardware
This chapter describes special instructions and problems concerning the SPARC
M10-4 hardware.

Notes and Restrictions

■
Problems with Hardware and Workarounds
■
Notes and Restrictions

Notes on using external DVD drive

USB bus power drive is not supported for external DVD drives connected via USB.

Notes on using USB memory

Prepare a USB memory as a medium in advance if you execute the command
specifying the USB memory as a destination of saving data, among XSCF commands.
The saved data contains information on the system. If you use the USB memory,
consideration should be made for the management of the USB memory in which the
data is saved, for security reasons.
Not all the commercially available USB memories of any manufacturer are
guaranteed for their connectivity and operability with XSCF. Abnormalities may
occur such as an XSCF firmware error or reset depending on your USB memories. In
such a case, immediately stop using the USB memory.
When connecting a USB memory to the USB port for XSCF, directly connect it to the
USB port. If you connect the USB memory via the USB hub or USB extension cable, it
may cause an error.
181