Fujitsu M10 Product Notes page 92

Table 3-5 Problems that might occur with XCP 2240 and workarounds (continued)
SPARC M10-
RTI No. 1 4 4S
RTIF2- x x x
141111-002
RTIF2- x x x
141204-001
Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2240 ･ March 2015
78
Description
Note that this problem occurs even if the
microSD card is replaced first.
If any of the following events occur and
the XSCF is reset, an incorrect error log
may be registered. In addition, the XSCF
time after the error occurrence time may
be initialized to January 1, 1970.
- XSCF panic
- watchdog timeout
- The RESET switch on the rear panel
pressed
The following two examples show the
cases when incorrect error logs are
registered and the error occurrence times
are also initialized.
[Example 1]
Date: Jan 01 09:05:40 JST 1970
Code: 80002008-000e010000ff0000ff-
018b00010000000000000000
Status: Alarm Occurred: Jan 01
09:04:56.276 JST 1970
FRU: /MBU
Msg: Hardware access error.
Diagnostic Code:
00000000 00000000 0000
00000000 00000000 0000
00000000 00000000 0000
00000000 00000000 00000000 00000000
00000000 00000000 0000
[Example 2]
Date: Jan 01 09:05:51 JST 1970
Code: 10000000-000e010000ff0000ff-
010240020000000000000000
Status: Information Occurred: Jan 01
09:05:35.008 JST 1970
FRU: /MBU
Msg: TWI access error
Diagnostic Code:
00000000 00000000 0000
00000000 00000000 0000
00000000 00000000 0000
00000000 00000000 00000000 00000000
00000000 00000000 0000
If the guest domain has been kept active
for a long time, powering off and then
powering on a physical partition (PPAR)
may cause the guest domain time to
Workaround
information.
- If the XSCF setting information is not
saved, execute the setpowerschedule(8)
command and reset the scheduled
operation.
There is no effective workaround.
Do not press the RESET switch unless it
is urgent and required.
[How to restore]
After turning off the power of the
physical partition (PPAR), turn off and
then turn on (AC OFF/ON) the input
power of the system. By turning on the
power again, the XSCF time is restored
automatically.
Immediately before powering off a
physical partition or resetting it, execute
the ldm add-spconfig from Oracle VM
Server for SPARC, and store the latest