Enabled - Fujitsu M10 Product Notes

Hide thumbs Also See for M10:
Table of Contents

Advertisement

primary#   ldm migrate ldg1 root@target-name
Target   Password:
Domain   ldg1   is   using   features   of   the   system   firmware   that   are   not   supported   in
  the   version   of   the   firmware   running   on   the   target   machine.
Domain   Migration   of   LDom   ldg1   failed.
When performing live migration from a SPARC M10 system with XCP 2210 or
newer, to another SPARC M10 system, make sure to update the XCP firmware of
the target system to XCP 2210 or newer.
Refer to the following table for the feasibility of performing live migration based
on the version of the firmware.
Table 3-4     Version of the firmware that support live migration
Migrate to
SPARC M10
Systems
(XCP 2230 or later)
Migrate from
available
SPARC M10
Systems
(XCP 2230 or later)
available
SPARC M10
Systems
(XCP 2210 or later)
available
SPARC M10
Systems
(XCP 2092 or
earlier)
available
SPARC T-series
SPARC M-series
(*1)
(SysFW 8.4 or later)
available
SPARC T-series
SPARC M-series
(*1)
(SysFW 8.3 or
earlier)
*1 It is a system like SPARC M5/M6 which supports Oracle VM Server for SPARC.
*2 Live migration is possible only for cpu-arch=generic.
Notes on a case when recovery mode of Oracle
VM Server for SPARC is enabled
Suppose that a system disk in a physical partition (PPAR (PPAR #A)) in which
recovery mode is enabled is switched to a system disk that has been used for
another PPAR (PPAR #B). The PPAR #A domain configuration information held
in the XSCF may be overwritten on the PPAR #B domain configuration information.
If you want to use recovery mode to switch the system disk to the system disk that
has been used for another PPAR and boot from the new system disk, perform the
SPARC M10
SPARC M10
Systems
Systems
(XCP 2210 or later)
(XCP 2092 or
earlier)
available(*2)
not available
available
not available
available
available
available
not available
available
available
SPARC T-series
SPARC T-series
SPARC M-series
SPARC M-series(*1)
(*1)
(SysFW 8.3 or earlier)
(SysFW 8.4 or later)
available
not available
available
available
available
available
available
not available
available
available
Chapter 3 Information on Software
37

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sparc m10

Table of Contents